NAD S170iAV - Manual (Page 32)

32
USING THE HTR 2 REMOTE CONTROL
LEARNING CODES FROM OTHER REMOTES
Begin by positioning the HTR 2 “nose-to-nose” with the source remote so the two devices’ infrared
windows are about 2 inches apart.
• Enter Learning Mode: On the HTR 2, simultaneously press-and-hold for 3 seconds both a Device
Selector key and the “record” key (just below the [DISP] key), until the Learn LED at the centre
of the HTR 2 turns steady green.
• Press the HTR 2’s Control key you wish to teach a command; the Learn LED will turn amber.
• Press-and-hold the control function key on the source remote: The HTR 2’s Learn LED will flicker amber
for a second or two, then turn solid green. The command is learned. Repeat this process for all
commands you wish to learn under the selected Device Selector key.
• Press the HTR 2’s Device Selector key again to exit the learning mode after you have completed
learning all commands for that Device.
NOTE
If the Learn LED does not flicker amber you may need to vary the distance between the remotes or
try fresh batteries in both remotes. If the Learn LED turns red rather than green, that particular
command of that source remote command has not been learned. Try again. In rare instances there
may be some IR format that is not compatible with the HTR 2.
CANCEL OPERATION
You can cancel configuring a key, by pressing the active Device Selector key beofre the learn is complete;
the Learn LED will turn red.
Example: Learning “DVD Pause”:
Position the HTR 2 and your DVD player’s remote as described above.
• On the HTR 2, simultaneously press-and-hold [DVD] and ; the Learn LED turns steady green.
• Press the HTR 2’s (pause) key; the Learn LED turns amber.
• Press-and-hold the DVD player’s remote’s pause key; the HTR 2’s Learn LED flickers amber and then
turns solid green. The command is learned.
• Press [DVD] again to exit the learning mode.
LIBRARY MODE
To enter the library mode, press and hold a device selector key and the AV Preset key for 3 seconds until
the status LED turns green. While in Library mode you can cycle through and test the different pre-
programmed tables in the remote to find if there is an appropriate table for your device. The several ways
of navigating the Library tables are described below. The Learn LED will flash twice when all available
tables have been transmitted.
DIGIT KEYS
The digit keys (0 - 9) can be used to directly select one of the tables. Enter the 3 digit table number. After
pressing the third digit the HTR 2 will automatically transmit the Power Off command as a test to be sure
you have selected the correct table.
CURSOR UP / CURSOR DOWN
The Cursor Up / Cursor Down keys can be used to cycle through the available tables. The HTR 2 will
transmit a test (Power Off) command after each press of the Cursor key. Holding down one of the Cursor
keys will cycle through all the available library tables at the rate of two per second, allowing you to quickly
find the correct table from the available tables.
NOTE
You can change the command transmitted for the test. If you press a key that is not used for anything
else in library mode, that command will be transmitted. Any subsequent test commands resulting
from changing tables will then use that command which you last pressed. This can be helpful with
some devices that do not have a standby mode, in which case the code searches do not work. For
example some CD players may not have a power off command, and you may want to use Play as your
test command instead.
ENGLISH
FRANÇAIS
DEUTSCH
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA