Quantum Instruments Cascade Laser Starter Kit - Manual (Page 38)

Chapter 8
Maintenance
8.1 Overview
This chapter describes all procedures of mainte-
nance and calibration for the QCL starter Kit. The
procedures described herein must be performed by
personnel trained on the electronic field, with ac-
ceptance by Alpes Lasers, otherwise the warranty
will be lost.
Note: The TTL Pulse Generator (TPG128) and
the Temperature Controller (TCU151) are calibrated
in factory.
8.1.1 How to remove the covers of
TCU151 and TPG128
Pull off the light gray plastic pieces of the side of the
front and back plates. Lift off the light gray plastic
shades form the side of the box, which gives access
to the screws holding the top and bottom covers.
37