Telenetics 56 - Manual (Page 12)

Installation
Page 4
Additional Items You Need
To install the Global Premier 56 mode, you need the following additional items:
™ A personal computer (PC)
™ A standard wall-mounted telephone jack located within 6 feet of your computer
™ A telephone for originating or answering calls with your Global Premier 56
™ A shielded serial cable with a 25-pin male connector for connecting to your Global Premier
56. The connector on the other end of the cable should match the requirements of your
computer or Data Terminal Equipment (DTE).
For asynchronous operation: Be sure the connector includes pins 2-8 and 20.
For synchronous operation: Be sure the connector includes pins 2-8, 15, 17, and 20.
Note: If you use fax software, be sure it supports Class 1 fax operation.
Installing Your Modem
The following procedure describes how to install your Global Premier 56 modem. You perform
these procedures using the connectors and jacks on the back of your Global Premier 56 modem
(see Figure 2 on page 5).
1.
Turn off your computer.
2.
Turn the power switch OFF on the back of your Global Premier 56 modem.
3.
Connect one end of the appropriately configured cable to your computer. Connect the other
end of the cable to the COMPUTER connector on the back of your Global Premier 56
modem.
4.
Connect either end of the supplied RJ-11 cable to a telephone wall jack. Connect the other
end of the cable to the WALL jack on the back of your Global Premier 56 modem.
5.
Plug the 2-prong end of the supplied power cord to the POWER connector on the back of
your Global Premier 56 modem. Use the latch at the top of the power cord to secure this