Telenetics 56 - Manual (Page 16)

Installation
Page 8
7.
When a window informs you that Windows has finished installing the new hardware device,
click Finish to complete the driver-installation procedure.
LEDs
The Global Premier 56 modem provides eight LED indicators. Table 2-6 lists the modem LED
indicators.
Table 2-6. LEDs Indicating Modem Control Signals
LED DTE Signal
PWR
DTR
DCD
RD
TD
OH
RTS
CTS
ON = Modem is receiving power
Data Terminal Ready
Data Carrier Detect
Received Data
Transmitted Data
Off Hook
Request To Send
Clear To Send
Modem Operation
By default, the Global Premier 56 modem is set up to not auto-answer incoming calls. If you
want the modem to answer calls automatically, set the S0 register to a value other than its default
value of zero. For example, issuing the AT command ATS0=1 configures the modem to auto-
answer calls after the first ring. These commands are typed from your computer or DTE
keyboard using terminal-emulation software such as HyperTerminal. For more information about
configuring your modem to auto-answer calls, refer to the S0 register on page 113.
If you change the auto-answer parameter, the new setting remains in effect until your modem is
powered-off. The next time your modem is powered-up, auto-answer is disabled again. To keep
auto-answer enabled each time the modem is powered-up, use the AT&W command to save
your changes in the modem’s nonvolatile memory. For more information about using this
command to store AT commands in nonvolatile memory, refer to the &W command on page 44.