Telenetics 56 - Manual (Page 53)

AT Commands
Page 45
Syntax &Z<value>
Defined Values
<value> Decimal number from 0 to 3 corresponding to the selected
telephone number.
<string> Dial string from 0 to 31 characters.
Result Codes
OK For <value> 3, and <string> 31 digits.
ERROR If <value> > 3, <string> > 31 digits, or if NVRAM is not installed
or is not operational..
%7 - Plug and Play Serial Number
Sets and stores eight serial numbers in hex format used for serial Plug and Play and for
ISA Plug and Play which use the Conexant 11596 Plug and Play device. Applicable to
Desktop configuration only.
Syntax %7<8 hex numbers><same 8 hex numbers>
Example
%7<8 hex numbers><same 8 hex numbers>
Result Codes
OK <8 hex numbers><same 8 hex numbers>
ERROR Otherwise
To display the stored serial number, issue AT"?<cr>.
%8 - Plug and Play Vendor ID and Product Number
Sets and stores Vendor ID and product number for serial Plug and Play and for ISA Plug
and Play which use the Conexant 11596 Plug and Play device. Applicable to Desktop
configuration only.
Syntax &8<3 ASCII characters><4 hex numbers><same 3 ASCII
characters><same 4 hex numbers><cr>
Example
%8<3 ASCII characters><4 hex numbers><same 3 ASCII
characters><same 4 hex numbers><cr>
Result Codes
OK <3 ASCII characters><4 hex numbers><same 3 ASCII
characters><same 4 hex numbers>
ERROR Otherwise
**- Load Flash Memory
The linear flash memory uploader allows flash memory connected to the modem external
memory bus to be upgraded with revised modem firmware. This process transfers
(uploads) the upgraded modem firmware (data) from the host computer to the modem
which transfers the data to the flash memory device. The linear flash memory
downloader allows the flash memory connected to the modem external memory bus to
read and saved. This process transfers (downloads) the current modem firmware (data) to
the host computer. Uploading new firmware to the flash memory or downloading existing
firmware from the flash memory device is a two-step process