Telenetics 56 - Manual (Page 46)

AT Commands
Page 38
Syntax Z<value>
Defined Values
<value> Decimal number corresponding to the selected profile.
0 Soft reset and restore stored profile 0.
1 Soft reset and restore stored profile 1.
Result Codes
OK <value> = 0 or 1.
ERROR Otherwise.
+FCLASS - Select Active Service Class
This command selects the active service class (mode).
Syntax +FCLASS=<mode>
Defined Values
<mode> Decimal number which corresponds to the selected service
class.
0 Select Data Mode (Default.)
1 Select Facsimile Class 1 Mode.
1.0 Select Facsimile Class 1.0 Mode.
2 Select Facsimile Class 2 Mode.
8 Select Voice Mode.
10 Reserved.
Result Codes
OK <value> = 0 or 1. For <mode> = 0, 1, 1.0, 2, 8, and 10
(SmartSCM only).
OK <value> = 0 or 1. For <mode> = 0, 1, 1.0, 8, and 10 (other than
SmartSCM).
ERROR Otherwise.
Reporting Current or Selected Values
Command: +FCLASS?
Response: +FCLASS:
<mode>
Example: +FCLASS: 0 For the default setting.
Reporting Supported Range of Parameter Values
Command: +FCLASS?
Response:
+FCLASS: (<mode> range)
Example: +FCLASS: (0,1,1.0,2,8,10)