Telenetics 56 - Manual (Page 183)

AT Commands
Page 175
127)<CRLF>.” The first “(20)” represents string length: the second (character values)
field reports supported string values.
1. The string is saved in RAM.
2. Non-numeric characters are not filtered out.
3. The string is right justified.
+FCR - Capability to Receive
Write syntax: +FCR=<value>
Valid values: 0 or 1
Default value: 0
+FCR=0 indicates that the DCE will not receive message data. This can be used when
the DTE has insufficient storage. The DCE can send and can be polled for a file.
+FCR is sampled in CCITT T.30 Phase A and Phase D.
+FPTS= - Page Transfer Status
Write Syntax: +FPTS=<ppr>
Valid values: 1, 2, 3, 4, 5
Default value: 0
The +FPTS parameter contains a value representing the post page response, including
copy quality and related end-of-page status. These values correspond to post page
response messages defined in T.30. The receiving DCE sets this parameter after it
receives a page of Phase C data. The transmitting DCE sets this parameter with the status
reported by the receiving station. The DTE may inspect or modify this parameter.
The set of <ppr> values is defined in Table A-25. These values are also reported in the
+FPTS response to the +FDR command.