Telenetics 56 - Manual (Page 93)

AT Commands
Page 85
The second case is where the modem is in the on-line
command state (waiting for AT commands) during a data
connection, and the \B is received in order to send a break to
the remote modem:
0 Clear data buffers and send break to remote modem.
1 Clear data buffers and send break to remote
modem.(Same as 0.)
2 Send break to remote modem immediately.
3 Send break to remote modem immediately. (Same as
2.)
4 Send break to remote modem in sequence with data.
5 Send break to remote modem in sequence with
transmitted data. (Default.)
The third case is where a break is received from a remote
modem during a non-error corrected connection:
0 Clears data buffers and sends break to the DTE.
1 Clears data buffers and sends break to the DTE.
(Same as 0.)
2 Send a break immediately to DTE.
3 Send a break immediately to DTE. (Same as 2.)
4 Send a break in sequence with received data to DTE.
5 Send a break in sequence with received data to DTE.
(Same as 4.) (Default.)
Result Codes
OK 0 to 5.
ERROR Otherwise.
-K - MNP Extended Services
Enables or disables conversion of a V.42 LAPM connection to an MNP 10 connection.
The parameter value, if valid, is written to S40, bits 0 and 1.
Syntax -K<value>
Defined Value
<value> Decimal number corresponding to the selected option.
0 Disables V.42 LAPM to MNP 10 conversion. (Default.)
1 Enables V.42 LAPM to MNP 10 conversion.
2 Enables V.42 LAPM to MNP 10 conversion; inhibits
MNP Extended Services initiation during V.42 LAPM
answer mode detection phase.
Result Codes
OK 0 or 2.
ERROR Otherwise.