Telenetics 56 - Manual (Page 164)

AT Commands
Page 156
Basic data mode and fax service class mode select commands are:
AT+FCLASS=0 <CR> for Data Mode
AT+FCLASS=1 <CR> for Service Class 1 Fax
AT+FCLASS=1.0 <CR> for Service Class 1.0 Fax
AT+FCLASS=2 <CR> for Service Class 2 Fax
In Class 2, the DCE makes and terminates calls, manages the communication session and
negotiates (T.30 protocol) and transports the image date to DTE. The T.4 protocol
management of image data, etc., is done by DTE.
The response to
AT+FCLASS= 0<CR> in Data Mode
or
AT+FCLASS=2<CR> in Service Class 2 Fax
is
OK
The service class may be set by the DTE from the choices available using the
“+FCLASS=<VALUE>” command.
General Rules
1.
+Fnnn commands must be entered completely, otherwise an ERROR response is
sent.
2.
All response messages are preceded and followed by <CR><LF>. Multiple response
commands (e.g., +FDIS: +FCSI: and +FDCS:) will, therefore, appear to a have a
blank line between them.
3.
Fax Class 2 commands can be separated by the “:” character. The “;” character can
be omitted if desired. Non-data commands cannot be separated by the “;” which is
allowed as a dial modifier.
4.
All Class 2 commands are assumed to be the final command on a command line.
Additional characters will be ignored.
5.
An ERROR message will be generated if any of the following conditions occur:
a. A Class 1 command is received while in Class 2.
b. A Class 2 command is received while in Class 1.