Telenetics 56 - Manual (Page 167)

AT Commands
Page 159
5.
Phase C base status reports: depending upon copy quality and related end-of page
status:
+FPTS: <1-5>
Procedure Interrupt Negotiation
CCITT allows a station to request a procedure interruption at the end of a page. This
request is passed between stations by the PIP, PIN, and PRI-Q messages.
Service Class 2 Identification and Selection
Three commands report identification and selection information. Each of these three
commands cause the DCE to send a message to the DTE. The messages are
programmable using ConfigurACE.
+FMFR? - Request Manufacturer Identification
The +FMFR? command causes the DCE to send a message identifying the DCE product
manufacturer. The default message is:
CONEXANT
OK
+FMDL? - Identify Product Model
The +FMDL? command causes the DCE to send a message identifying the DCE product
model.
+FREV? - Identify Product Revision
The +FREV? command causes the DCE to send a message identifying the DCE product
model revision number. The message format is the same as the ATI3 message, e.g.:
VX.X-F_A
OK