Telenetics 56 - Manual (Page 134)

AT Commands
Page 126
Cellular Phone Drivers
The data interface to cellular phones differs between manufacturers and models and
requires a unique cellular phone driver for each phone or group of phones. Therefore the
particular phone driver needs to be downloaded from the PC into the modem's RAM
before the modem can be used directly with the cellular phone. If a driver is not loaded
the modem will operate as a normal landline modem.
Cellular Commands
^C2 - Download Cellular Phone Driver
The ^C2 command initiates the cellular phone driver download function. Upon receipt of
the command, the modem issues the "OK" message. The user then performs an ASCII
download of the driver (in .S37 format) from the host to the modem, typically using a
communications software package (with transmit pacing turned off).
^C2 Download Cellular Phone command
Result Codes
OK
[Download Process]
OK Cellular phone driver download completed successfully
ERROR Cellular phone driver download not completed successfully, e.g.,
checksum of record (in S37 file) is not correct, driver size is larger than 2k bytes, or an
invalid driver is downloaded, or modem is connected.
^I - Identify Cellular Phone Driver
The modem reports the identification of the loaded cellular phone driver in response to
the ^I command. The response is dependent upon the driver.
Result Codes (Typical):
CELLULAR DRIVER: OKI 900/910
(c) Copyright 1999, Conexant Systems, Inc.
Version 1.00 Thu Jan 10:29:52 1998
OK
or
ERROR Cellular phone driver is not loaded
^T6 - Indicate Status of Cellular Phone
The status of the cellular phone connected to the modem is reported in response to the
^T6 command. The status is reported in a single byte formatted as a decimal number.
The individual status signals assigned to the status byte bits are:
bit 0 1 = Cellular phone is receiving an incoming call