Telenetics 56 - Manual (Page 180)

AT Commands
Page 172
+FPTS: - Transmit Page Transfer Status
Syntax +FPTS:<ppr>
The +FPTS: response reports a <ppr> number representing the copy quality and related
post-page message responses received from the remote DCE. The valid <ppr> values are
defined in Table A-26.
The +FPTS:<ppr> response is generated in execution of a +FET=<ppm> command.
+FHNG: - Call Termination with Status
Syntax +FHNG:<hangup status code>
+FHNG indicates that the call has been terminated. The hangup cause is reported and
stored in the +FAXERR parameter for later inspection. The <hangup status code>
values are described in Table A-27.
+FHNG:<hsc> is a possible intermediate result code to any DTE action command
described in this appendix. It is always followed by the OK final result code.
Upon termination of a call, the DCE determines the cause of termination and reports it as
part of the FHNG:<hsc> response. It also stores this <hsc> code in the +FAXERR
parameter for later inspection.
The hangup values are organized according to the phases of the facsimile transaction as
defined by T.30. The table values are in decimal notation. Leading zero characters are
optional.
+FCIG: - Report the Polled Station ID
Syntax +FCIG: “< ID string>” Polled Station ID
This response reports the received transmit station ID string, if any. This message is
generated in execution of Originate, Answer, +FDT, or +FDR commands.
+FDTC: - Report the Polled Station Capabilities
Syntax +FDTC: “< string>” Polled Station Capabilities
If the answerer has a document to poll, it would be communicated to the originator in bit
9 of the DIS frame. The originating station may elect to transmit a fax, and later, send
SIG and DTC frames to pick up the polled document. The answering station would
report the incoming DTC frame via the +FDTC: response message after command mode
is canceled with the AT+FDR command.