Telenetics 56 - Manual (Page 3)

Page iii
FCC Requirements
This device complies with Part 15 Class B of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 Class B of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
™ Reorient or relocate the receiving antenna.
™ Increase the separation between the equipment and the receiver.
™ Connect the equipment to an outlet on a circuit other than the one to which the receiver is
connected.
™ Consult the dealer or an experienced radio/TV technician for help.
If none of these actions resolves the problem, consult your distributor or an experienced
radio/television technician for additional suggestions.
Additionally, Section 15.838, paragraph d), of the FCC Rules and Regulations states: “Where
special accessories, such as shielded cables, are required in order to meet FCC regulations,
shielded cables must be used with this equipment. Operation with non-approved equipment or
unshielded cables is likely to result in interference to radio and TV reception. The user is
cautioned that changes and modifications to this equipment without the approval of the
manufacturer could void the user’s authority to operate this equipment.
Department of Canada Statement
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numerique de la classe A respecte toutes les exigences du Reglement sur le materiel
brouilleur du Canada.