Telenetics 56 - Manual (Page 201)

AT Commands
Page 193
+VSM - Compression Method Selection
This command causes the modem to set the voice compression method, the
silence compression sensitivity, and the voice sampling rate.
Reporting Supported Range of Parameter Values
Syntax +VSM=<cml>,<vsr>,<sds>,<sel>
Defined Values
<cml> Decimal number identifying the compression method.
<vsr> <range of values> containing the supported range of voice
samples per second of the analog signal.
<scs> <range of values> containing the supported range of sensitivity
settings for voice receives.
<sel> <range of values> containing the supported range of expansion
values for voice transmits.
Reporting Current or Selected Values
Command: +VSM?
Response: <cml>,<vsr>,<sds>,<sel>
Example:
1,8000,0,0 For the default setting.
Reporting Supported Range of Parameter Values
Command: +VSM=?
Response: <cml>,<cmid>,<bps>,<tm>,<vsr>,<sds>,<sel>
<cml> Decimal number identifying the compression
method (1, 129, 130, 140, or 141).
<cmid> Alphanumeric string describing the compression
method (UNSIGNED PCM, IMA ADPCM,
UNSIGNED PCM, 2 Bit ADPCM, or 4 Bit
ADPCM).
<bps> Decimal number defining the average number
of bits in the compressed sample not including
silence compression (2, 4 or 8).
<tm> Decimal number (0) reporting the time interval,
in units of 0.1 second, between timing marks. A
value of 0 reports that timing marks are not
supported.
<vsr> <range of values> containing the supported
range of voice samples per second of the
analog signal (8000).
<scs> <range of values> containing the supported
range of sensitivity settings for voice receives
(0). A 0 indicates not supported.
<sel> <range of values> containing the supported
range of expansion values for voice transmits
(0). A 0 indicates not supported.
Example: 1,"UNSIGNED PCM",8,0,8000,0,0
129,"IMA ADPCM",4,0,8000,0,0
130,"UNSIGNED PCM",8,0,8000,0,00
140,"2 Bit ADPCM",2,0,8000,0,0
141,"4 Bit ADPCM",4,0,8000,0,0
OK
Result Codes
OK Valid range.