Telenetics 56 - Manual (Page 98)

AT Commands
Page 90
answer negotiation.
5 Enable DCE-controlled V.8 answer negotiation with
+A8x indications.
<v8cf Set the V.8 CI signal call function to the hexadecimal octetXY.
00 (Default.)
21
C1
<v8b> Decimal number which enables/disables V.8bis negotiation.
0 Disable V.8bis negotiation.
1 Enable V.8bis negotiation. (Default.)
<cfrange> “<string of values>“. Applicable only for <v8a>=5. Not
supported.
< protrange > “<string of values>“. Applicable only for <v8a>=5. Not
supported.
Default values: 1,1,00,1,0,0
The ATD and ATA commands behave as specified in V.250, and +A8n indications
are not generated by the modem.
For subparameter values <v8o>=6 and <v8a>=5, the +A8I indications are issued
during the course of the V.8 session to notify the DTE when the relevant V.8 signals
are received.
Reporting Current or Selected Values
Command: +A8E?
Response: +A8E:
<v8o>,<v8a>,<v8cf>[,<v8b>][,<cfrange>][,<protrange>]
Example: +A8E: 1,1,00,1,0,0 For the defaults
Reporting Supported Range of Parameter Values
Command: +A8E?
Response:
+A8E: (<v8o> range),(<v8a> range),(v8cf in octets), (<v8b>
range),(<cfrange>),(<protrange>)
Example: +A8E: (1,6),(1,5),(0,21,C1),(0,1),(0),(0)
+A8I: - CI Signal Indication
This indication is issued by an answering modem, if +A8E,<v8a> 0, to indicate detection
of a V.8 CI signal, and report the recovered Call Function octet(s).
Indication
Syntax +A8I:<v8cf><CR>
Defined Value
<v8cf> A hexadecimal code octet representation of those Call Function
octet(s). +A8I:0 indicates that the modem timed out waiting for
CI.
Example
+A8I:0 The modem timed out waiting for CI.
+A8I:X YYY