Telenetics 56 User Manual
Page 58
AT Commands
Page 50
Syntax
X<value>
Defined Values
<value> Decimal number corresponding to the option.
0 0 Disables reporting of busy tones unless forced
otherwise by country requirements; send only OK,
CONNECT, RING, NO CARRIERERROR, and NO
ANSWER result codes. Blind dialing is
enabled/disabled by country parameters. If busy tone
detection is enforced and busy tone is detected, NO
CARRIER will be reported. If dial tone detection is
enforced or selected and dial tone is not detected, NO
CARRIER will be reported instead of NO DIAL TONE.
The value 000b is written to S22 bits 6, 5, and 4,
respectively
1 Disables reporting of busy tones unless forced
otherwise by country requirements; send only OK,
CONNECT, RING, NO ERROR, NO ANSWER, and
CONNECT XXXX (XXXX = rate). Blind dialing
enabled/disabled by country parameters. If busy tone
detection is enforced and busy tone is detected, NO
CARRIER will be reported instead of BUSY. If dial tone
detection is enforced selected and dial tone is not
detected, N CARRIER will be reported instead of NO
DIAL TONE. The value 100b is written to S22 bits 6 5,
and 4, respectively
2 Disables reporting of busy tones unless forced
otherwise by country requirements; send only OK,
CONNECT, RING, NO CARRIER, ERROR, NO DIAL
TONE, NO ANSWER, and CONNECT XXXX. If busy
tone detection is enforced and busy tone is detected,
NO CARRIER will be reported instead of BUSY. If dial
tone detection is enforced or selected and dial tone is
not detected, NO DIAL TONE will be reported instead
of NO CARRIER. The value101b is written to S22 bits
6, 5, and 4, respectively.
3 Enables reporting of busy tones; send only OK,
CONNECT, RING, NO CARRIER, ERROR, NO
ANSWER, and CONNECT XXXX. Blind dialing is
enabled/disabled by country parameters. If dial tone
detection is enforced and dial tone is not detected, NO
CARRIER will be reported. The value 110b is written to
S22 bits 6, 5, and 4, respectively.
4 Enables reporting of busy tones; send all messages.
The value 111b is written to S22 bits6, 5, and 4,
respectively. (Default.)
Result Codes
OK <value> = 0 to 4.
ERROR Otherwise.