Telenetics 56 - Manual (Page 173)

AT Commands
Page 165
The remote facsimile station should respond to the post page message with a post page
response. The DCE will report this using the +FPTS:<ppr> response (Table A-25).
End a Page
The +FET= command causes the DCE to append an RTC (6 EOL) pattern as needed and
enter Phase D by sending the selected T.30 Post Page message.
The +FET=1 (EOM) command signals the remote station that the next document will
have a new DCS negotiated; this causes the session to re-enter Phase B.
Table A-24. T.30 Post Page Message Codes
ppm Code Mnemonic Description
0 [PPS-]MPS Another page next, same document
1 [PPS-]EOM Another document next
2 [PPS-]EOP No more pages or documents
3 PPS-NULL Another partial page next
4 [PPS-]PRI-MPS Another page, procedure interrupt
5 [PPS-]PRI-EOM Another doc., procedure interrupt
6 [PPS-]PRI-EOP All done, procedure interrupt
=8+ppm Post Page Message (ppm code)
Table A-25. T.30 Post Page Response Messages
ppr Code Mnemonic Description
1 MCF Page good
2 RTN Page bad; retrain requested
3 RTP Page good; retrain requested
4 PIN Page bad; interrupt requested
5 PIP Page good; interrupt requested