Telenetics 56 - Manual (Page 204)

AT Commands
Page 196
Reporting Current or Selected Values
Command: +VPR?
Response: <rate>
Example:
0 For the default setting (Autobaud).
Reporting Supported Range of Parameter Values
Command: +VPR=?
Response: (<rate>
range)
Example: (0,1,2,3,4,8,16,24,48,96)
Result Codes
OK <rate> = 0,1,2,3,4,8,16,24,48,96.
ERROR Otherwise, or if not in Voice Mode.
Speakerphone Commands
+VSP - Speakerphone ON/OFF
This command turns the speakerphone ON or OFF
Syntax +VSP=<mode>
Defined Values
<mode> Decimal number corresponding to the selected option.
0 The speakerphone function is OFF. (Default.)
The speakerphone function is ON.
Reporting Current or Selected Values
Command: +VSP?
Response: <rate>
Example:
0 For the default setting.
Reporting Supported Range of Parameter Values
Command: +VSP=?
Response: (<mode>
range)
Example: (0,1)
Result Codes
OK <mode> = 0 or 1.
ERROR Otherwise, or if not in Voice Mode.
+VDX - Speakerphone Duplex Mode
This command selects speakerphone full duplex mode.
Syntax +VDX=<mode>
Defined Values
<mode> Decimal number corresponding to the selected option.
1 The speakerphone mode is full duplex.
Reporting Current or Selected Values
Command: +VDX?
Response: <mode>
Example:
1 For the default setting.
Reporting Supported Range of Parameter Values
Command: +VDX=?
Response: (<mode>
range)
Example: (1)
Result Codes
OK <mode> = 1.
ERROR Otherwise, or if not in Voice Mode.