Telenetics 56 - Manual (Page 73)

AT Commands
Page 65
OK <value> = 0 to 3.
ERROR Otherwise.
&G - Select Guard Tone
This command causes the modem to generate the guard tone selected by this command
(DPSK modulation modes only). The parameter value, if valid, is written to S23, bits 6
and 7.
Syntax &G<value>
Defined Values
<value> Decimal number corresponding to the selected option.
0 Disables guard tone. (Default.)
1 Disables guard tone.
2 Selects 1800 Hz guard tone.
This command may not be permitted in some countries.
Result Codes
OK <value> = 0 to 2.
ERROR Otherwise.
&P - Select Pulse Dial Make/Break Ratio
This command determines the make/break ratio used during pulse dialing. It is only
effective if the appropriate bit to enable this command is set through the ConfigurACE
program. If enabled, it will override the make/break ratios in the OEM parameters in
ConfigurACE. The default is country-dependent. The parameter value, if valid, is
written to S28, bits 3 and 4.
Syntax &P<value>
Defined Values
<value> Decimal number corresponding to the selected option.
0 Selects 39%-61% make/break ratio at 10 pulses per
second. (Default.)
1 Selects 33%-67% make/break ratio at 10 pulses per
second.
2 Selects 39%-61% make/break ratio at 20 pulses per
second.
3 Selects 33%-67% make/break ratio at 20 pulses per
second.
Result Codes
OK <value> = 0 to 3.
ERROR Otherwise.
&V - Display Current Configuration and Stored Profiles
This command reports the current (active) configuration, the stored (user) profiles, and
the first four stored telephone numbers. The stored profiles and telephone numbers are
not displayed if the NVRAM is not installed or is not operational as detected by the
NVRAM test during reset processing.
Result Codes
OK