UTStarcom UT-300R2 - Manual (Page 25)

Chapter 4 Web-based Management 23
2 Also under the VPI/VCI , you will need to enter two
numbers, the VCI and VPI values. These numbers are
used to define a unique path for your connection. Your ISP
should give you the specific settings for the VPI and VCI
numbers to enter. Type in the correct values assigned by
your ISP.
3 Select the Encapsulation type (LLC or VcMux) radio
button that corresponds to the encapsulation in use by
your ISP.
4 When you are satisfied that all the WAN settings are
configured correctly, click on the
Apply button.
5 The new settings must be saved and the UT-300R2 must
be restarted for the settings to go into effect. To manually
save and reboot the UT-300R2, click on the
Tools
directory tab and then click the System menu button. On
the menu that appears, click he Save & Restart button.
The UT-300R2 will save the new settings and restart.
Upon restarting the UT-300R2 will automatically establish
the bridged WAN connection.
Note: Some accounts use PPP connection software for their
Internet service connection. If you have been given a CD with
PPP connection software, install this now as instructed by your
service provider. After the UT-300R2 has rebooted it will
negotiate the ADSL connection. Use the connection software to
log on to the ISP network and access the Internet.