UTStarcom UT-300R2 - Manual (Page 56)

54 Chapter 5 Advanced Configuration / Network Management
Figure 22 Filters Configuration Menu − MAC Filters
Previously entered or default MAC filter rules are listed in the
MAC Filters List at the bottom of the page. When you
configure an additional MAC filter rule and click the Apply
button, the new rule will be added to this list.
Select to enable or disable IP filter in Status option, the default
is “Enabled”. Then enter a name for the rule in the Name blank,
for easier identification later. Click
Clear button to delete the
entered name. Next enter the MAC address of the computer on
the LAN (Local Area Network) side.
You may read the DHCP client's host name and MAC address
listed from DHCP Client drop-down menu. Select the client
computer, which you want to add on the MAC filter list and then