UTStarcom UT-300R2 - Manual (Page 68)

66 Chapter 5 Advanced Configuration / Network Management
RIP
Figure 28 RIP menu
RIP can be enabled on any existing WAN or LAN interfaces. It
may be specified to receive RIP requests and reply to them, it
can be specified to send RIP queries, or to both receive and
send RIP packets. Furthermore, the RIP version can be
specified. The table below lists the parameters that can be
specified for the pull-down RIP menus. Click the
Apply button
to setup RIP as specified.
Current RIP configurations cannot be edited. To remove a RIP
configuration, click on the trashcan icon for the set. Remember
to save the configuration changes.