UTStarcom UT-300R2 - Manual (Page 37)

Chapter 4 Web-based Management 35
clients on the LAN will automatically get DNS settings relayed
from the UT-300R2 as they are entered here. Alternatively, if
DNS Status is disabled, workstations must be configured to
initiate DNS requests for each session, and therefore you must
configure DNS settings for the workstations.
Figure 15 Configure DNS IP address
Usually an ISP will provide you with one or two DNS server IP
addresses. Enter these IP addresses in the available entry
fields for the
Primary DNS Server and the Secondary DNS
Server .
If you do not want to use the UT-300R2 as a DNS proxy agent,
change the
DNS Status to Disabled .
When you have configured the DNS settings as desired, click
the
Apply button. Be sure to save the settings.
Configuring the LAN Connection
The first step in configuring your LAN is to determine the IP
address scheme that the computers on your LAN will use. The