UTStarcom UT-300R2 - Manual (Page 31)

Chapter 4 Web-based Management 29
Figure 12 WAN Settings - Dynamic IP Address (DHCP)
1 From the WAN Setting page, select the PVC you want to
configure from the seven available PVCs, using the drop-
down menu.
2 You can also specify the VPI/VCI numbers (assigned to
this PVC by your ISP) that will be used to uniquely identify
this PVC to your ISP. You can also enter of modify these
two numbers later during the configuration process.
3 Click the Add button, at the bottom of the page, to add the
new configuration to the list of active PVCs. This will open
the
WAN Setting configuration screen, shown above.
4 Click to select the DHCP radio button listed in the
Connection Type options list. The menu will change to
offer a different set of configuration options and will appear
as shown above when DHCP is selected.
5 If you are instructed to use enable Default Route by your
ISP, click the Enabled radio button. This setting specifies
that this PVC (from the list of seven) on your UT-300R2 be
used to define the default route to the Internet for your LAN.