UTStarcom UT-300R2 - Manual (Page 27)

Chapter 4 Web-based Management 25
Figure 11 WAN Settings Menu – Routed/Bridged Mode
Note: Please note that the menu shown above will change
depending on which WAN Type and Connection Type you
select.
1 Click to select the RFC2684Bridged radio button in the
WAN Type options list if your ISP uses DHCP to assign
you an IP address that is valid on the WAN (Internet). This
is the most common type of bridged connection offered by
ISPs.
2 Also under the VPI/VCI , you will need to enter two
numbers, the VCI and VPI values. These numbers are
used to define a unique path for your connection. Your ISP
should give you the specific settings for the VPI and VCI
numbers to enter. Type in the correct values assigned by
your ISP.