Xilinx IP Ethernet AVB Endpoint v2.4 UG492 - Manual (Page 169)

Ethernet AVB Endpoint User Guide www.xilinx.com 169
UG492 September 21, 2010
Time Stamp Accuracy
RTC Sampling Error
It has to be assumed that the RTC reference clock is of a different frequency to the MAC
transmitted and receiver clocks. Therefore, the RTC sampling logic has to be
asynchronous.
There are a number of methods to obtain a time stamp across an asynchronous clock
boundary. The simplest method, is to simply pass a toggle signal from the Tx/Rx domain
into the RTC reference clock domain whenever a time stamp is required. This method
should only result in an uncertainty of one cycle: the logic is illustrated in
Figure A-2 .
In Figure A-2 , the Sample Timestamp signal is generated whenever the Tx/Rx time
stamp position is detected (see “Time Stamp Sampling Position of MAC Frames” ). From
this, a toggle signal is generated as illustrated, and this is passed across the clock domain
from Tx/Rx MAC clock to the RTC reference clock domain.
When in the RTC clock domain, the toggle signal is re-clocked using the two
synchronization flip-flops illustrated. After this, an edge detection circuit is used to
determine that the RTC should be sampled.
The single clock period of uncertainty arises from the behavior of the first synchronization
flip-flop.
Figure A-3 illustrates that the rising edge of the toggle signal can occur very
close to the clock edge of the RTC reference clock. It is possible that the setup timing of this
flip-flop could be violated, resulting in uncertainty as to whether a logic ‘0’ or a logic ‘1’
will be sampled. If the flip-flop samples logic ‘1’, the result is Timing Case 1; if the flip-flop
samples logic ‘0’, Timing Case 2 results.
The overall result of this is to obtain a single Reference Clock Period of uncertainty in the
captured time stamp value.
X-Ref Target - Figure A-2
Figure A-2: RTC Sampling Logic
D Q
CE
Take Timestamp
(SFD detected on
MAC Client I/F)
MAC Tx/Rx clock
D0 Q0 D1 Q1 D2 Q2
XOR
Take RTC
Sample
RTC Reference
Clock (rtc_clk)
synchronisation pair
toggle
clock
boundary