P802.1qav, Talker assumptions, Listener assumptions – Xilinx IP Ethernet AVB Endpoint v2.4 UG492 User Manual
Page 31
Ethernet AVB Endpoint User Guide
31
UG492 September 21, 2010
AVB Specifications
P802.1Qav
This specification defines the mechanism for queuing and forwarding AV traffic from a
talker to a listener across the network. This can involve several network hops (network
bridge devices that the data must pass through).
P802.1Qav is also responsible for enforcing the 75% maximum bandwidth restriction
across each link of the network that can be reserved for the AV traffic.
Only a subset of the P802.1Qav requirements for an Endpoint is implemented in the
Ethernet AVB Endpoint core, with the following assumptions for talkers and listeners:
Talker Assumptions
•
AV traffic Ethernet frames that are input to the Ethernet AVB Endpoint use the VLAN
priority values that the Bridges in the network recognize as being associated with SR
classes exclusively for transmitting stream data.
•
Legacy traffic Ethernet frames that are input to the Ethernet AVB Endpoint do not use
the VLAN priority values that the Bridges in the network recognize as being
associated with SR classes exclusively for transmitting stream data.
•
The credit shaping algorithm operates on the AV traffic port; so in order to comply
with the transmission selection rules for P802.1Qav, all Ethernet frames input on the
AV traffic port are assumed to be of the same SR Class. However, the Ethernet AVB
Endpoint does not enforce this rule and it is acceptable to send a mix of SR Class A
and SR Class B Ethernet frames on the AV traffic port. In this case the Ethernet AVB
Endpoint will not prioritize SR Class A Ethernet frames over SR Class B Ethernet
frames; instead it will apply the credit-based shaper algorithm to all of the Ethernet
frames that are input on the AV traffic port.
•
The Ethernet AVB Endpoint assumes that any per-stream traffic management has
been done prior to AV traffic being input on the AV traffic port. To comply with the
transmission selection rules for P802.1Qav it is assumed that if multiple streams are
input to the Ethernet AVB Endpoint via the AV traffic port, that the credit-based shaper
algorithm has been used per stream as the transmission selection mechanism, prior to
the AV traffic being input on the AV traffic port.
•
If multiple AV streams are input to the Ethernet AVB Endpoint via the AV traffic port,
it is assumed that the IdleSlope/SendSlope control registers (See
“Tx Arbiter Idle Slope Control Register”
) are
programmed correctly to be the sum of the IdleSlope /SendSlope values for all the
streams that are input on the AV traffic port. The credit-based shaper algorithm used
on the AV traffic port will enforce a hiLimit/loLimit on the credits to ensure that this
interface is not misused.
Listener Assumptions
•
The Ethernet AVB Endpoint provides a mechanism for identifying received AV traffic
for either one or two SR classes (see
“Rx Filtering Control Register”
); however, it does
not provide any buffering for AV traffic Ethernet frames. Buffering is expected to be
done outside the Ethernet AVB Endpoint, after it has separated out the AV traffic
Ethernet frames, as the buffering requirements are expected to be application-specific.