Xerox DocuColor 2060 - Manual (Page 102)

P A P E R A N D P A P E R T R A Y S
D O C U C O L O R 2 0 6 0 / 2 0 4 5 O P E R A T O R M A N U A L 3–10
Drilled Paper
3-hole drilled paper can be run only from Trays 1, 2, and 3. 3-hole drilled paper
does not run reliably from the optional Tray 4.
Drilled paper should be run in the Simplex (1-sided) and Duplex (2-sided)
orientations shown below to avoid paper jams caused by the holes not aligning
correctly with the paper sensor in the press.
Simplex Print Jobs
Load the drilled paper into Trays 1, 2, or 3 Long Edge Feed (LEF) with the holes at
the lead edge position. Refer to the following illustration:
Duplex Print Jobs
Load drilled paper into Trays 1, 2, or 3 with the holes positioned toward the rear
of the paper tray. Refer to the following illustration:
NOTE: If you are stapling 3-hole drilled paper with the optional High Capacity
Stacker Stapler, refer to the Accessories chapter for paper loading instructions,
based on the position of the staple.
Rear of paper tray
Front of paper tray
guides
Tray 3
Rear of paper tray
Front of paper tray
Trays 1 and 2
Paper
tray
guides
Left
side tray
Paper Right
side
Rear of paper tray
Front of paper tray
Trays 1, 2, and 3
Paper
tray
guides