Xerox DocuColor 2060 - Manual (Page 222)

A C C E S S O R I E S T R A Y 4
D O C U C O L O R 2 0 6 0 / 2 0 4 5 O P E R A T O R M A N U A L 5–10
4
Remove any remaining sheets from the Elevator Tray if you are changing paper
stock.
5
Load the paper seam side (the side where the ream of paper is sealed) up in
Tray 4.
Load the paper onto the Elevator Tray with the sheets even against the front and
lead edge registration guides. DO NOT fill above the MAX line. Ensure that the
side edge and end guides are against the paper. Incorrect loading of paper can
result in excessive sheet skew, misfeeds, or multiple feeds due to paper guides
not being aligned properly.
KEY POINT: Tray 4 is an accessory shared with other printers. The Front
Edge Paper Stop button is used for smaller sized paper that can be run on other
printers. It has no functional use on the DocuColor 2060/2045.
Although Tray 4 has auto size detection capability, the paper weight (g/m
2
) range
must be selected on the Weight Indicator. Selecting the correct paper weight
range affects the feed performance and Image Quality.
6
Press the button until the light next to the correct weight is illuminated.
KEY POINT: When the tray elevator lowers while loading paper, or after
clearing a jam in Tray 4, make sure that the paper is registered evenly against the
front and lead edge guides. This is most important when the tray is full of paper
because the tray can tilt to compensate for curl or other conditions, and the top
of the stack moves away from the front edge guides.