Xerox DocuColor 2060 - Manual (Page 112)

S C A N N E R
D O C U C O L O R 2 0 6 0 / 2 0 4 5 O P E R A T O R M A N U A L 4–2
Basic Scanning Steps
If the DADF belt is dirty and the original is a thin or transparent document,
background may appear on the copy. This may also occur when copies are made
using the Document Glass. Place a white sheet of paper of the same size on top
of the document being copied to eliminate background until the belt is cleaned.
Use the following steps for one-sided copies. Refer to the Basic Features section
for two-sided copies.
1
Touch the Basic Features tab.
2
Press the Clear All button to clear any previous programming.
3
Lift the DADF and place the original face down on the Document Glass and close
the DADF. Do not press down on the DADF with excessive force when scanning
thick originals such as books.
4
Ensure that the document is registered using the same orientation on the
Document Glass as the paper in the chosen paper tray (that is, LEF on the glass if
the paper in the chosen paper tray is LEF; SEF on the glass if the paper in the
chosen paper tray is SEF).
Figure 1. Original Registration on the Document Glass