Xerox DocuColor 2060 - Manual (Page 58)

O V E R V I E W
D O C U C O L O R 2 0 6 0 / 2 0 4 5 O P E R A T O R M A N U A L 2–8
Ground Fault Indicator (GFI) Circuit Breaker
The DocuColor 2060/2045 is equipped with an additional safety circuit breaker
called a Ground Fault Indicator. This device trips if the power to the digital press
is interrupted.
Figure 5. Digital Press GFI Circuit Breaker
The digital press should be powered on as soon as possible after the power is
restored, and a print should be made to ensure that no damage to the DocuColor
2060/2045 has occurred.
If power to the digital press is interrupted, do the following:
1
Locate the circuit breaker on the back of the digital press on the electrical
module next to the toner waste bottle.
2
If the device has been tripped, the switch will be in the Off position (down). Flip
the switch up.
NOTE: If the device trips again, or if power is not restored by the above
procedure, call your Xerox service representative.
CAUTION: The Pressure Pad in the Fuser remains in a up position if power to
the digital press is interrupted while the digital press is in use. The Pressure Pad
will not be released from this position until the power is restored, the Power
Switch is in the On position, and the Start button is pressed.
If the Pressure Pad remains in the up position for a prolonged period of time, print
quality defects will occur.
GFI
Module
Ecology