Xerox DocuColor 2060 - Manual (Page 219)

T R A Y 4 A C C E S S O R I E S
D O C U C O L O R 2 0 6 0 / 2 0 4 5 O P E R A T O R M A N U A L
AC
CESSO
RIES
5–7
Tray 4 Special Features
Special features help control the environmental conditions in the paper tray to
ensure optimum print capability:
• Paper Tray 4 has an optional heater kit available.
Loading Special Stock in Tray 4
To ensure that the output is correct follow the orientation shown on the Tray 4
indicator when loading special stock.
Tabbed Inserts
Tabbed Inserts can be run from Tray 4 but it is not recommended. Load the non-
tabbed, short edge of the tabbed insert as the lead edge, and select non-
standard paper. If a jam occurs while running tabbed sets, there is no recovery
procedure. You have to manually reassemble your originals and prints, determine
where the job left off and resume printing or cancel the job and start again.
The size of the tabbed insert should be 9 x 11 inch (229 x 279 mm) for letter size
tabs (223.5 x 296 mm for A4 equivalent tabs). Select the proper weight of the
insert on the tray. Select Non-standard size and input 11 inches or 296 mm for A4
as the X axis and 9 inches or 223.5 mm for A4 as the Y axis dimensions for SEF.
Refer to the System Administration Guide, Tools Mode chapter, for programming
non-standard size paper.
KEY POINT: If you are using drilled Tabbed Inserts, you may experience
sporadic jams caused by the holes passing over the sensors.