Xerox DocuColor 2060 - Manual (Page 101)

P A P E R A N D P A P E R T R A Y S
D O C U C O L O R 2 0 6 0 / 2 0 4 5 O P E R A T O R M A N U A L
PA
P
E
R
A
N
D
PA
P
E
R
TR
A
Y
S
3–9
Transparency Guidelines
Transparencies can be run ONLY from Tray 3.
Use only the transparencies recommended:
• Xerox Removable Paper Stripe: USA and Canada, 3R5765; Xerox
Europe, 3R93179.
• Load transparencies into Tray 3 with the paper stripe side facing DOWN and
with the stripe as the leading edge. (The leading edge is the edge that feeds
into the digital press first.)
• Do not mix paper and transparencies in Tray 3. Jams may occur.
• Ensure that Transparency is selected in the weight section on the paper tray.
Tabbed Inserts
Tabbed Inserts can be loaded into Tray 3 as non-standard paper.
• Tabbed inserts can be run from, but are not recommended for, optional Tray 4
as non-standard paper.
• When loading, the non-tabbed, short edge of the tabbed insert should be the
lead edge to the digital press.
• If a jam occurs while running tabbed sets, there is no recovery procedure.
• You have to manually reassemble your originals and prints, determine
where the job left off, and resume printing or cancel the job and start
again.
• The size of the tabbed insert should be 9 x 11 inch (229 x 279 mm) for letter
size tabs (223.5 x 296 mm for A4 equivalent tabs).
• The proper weight of the insert should be selected on the tray.
• Select Non-standard size and input 11 inches or 296 mm for A4 as the X axis
and 9 inches or 223.5 mm for A4 as the Y axis dimensions for SEF.
Refer to the System Administration Guide for the procedure to program non-
standard size paper.