Xerox DocuColor 2060 - Manual (Page 192)

S C A N N E R
D O C U C O L O R 2 0 6 0 / 2 0 4 5 O P E R A T O R M A N U A L 4–82
Transparency Options
Transparency Options allows you to do the following:
• Transparency Set produces a single set of transparencies with a
designated number of sets of paper output. Only one set of transparencies is
produced regardless of the number of paper sets requested.
• Transparency Set + Dividers produces a single set of transparencies +
dividers with a designated number of sets of paper output. Only one set of
transparencies is produced regardless of the number of paper sets required.
• Dividers Only produces a continuous stream of dividers to be incorporated
into a job programmed for transparencies only. This is the option to choose if
you are running multiple sets of transparencies and require a divider to be
inserted between each set.
Off is the permanent default for Transparency Options. The default cannot be
changed in Tools Mode.
Tray 3 is automatically selected when Transparency Options is selected.
Transparencies should be run from Tray 3 ONLY. If you have an optional Tray 4 you
can run transparencies but it is not recommended. Any other tray may be
selected for Dividers. If Transparency Options is selected and paper is in Tray 3, a
message appears in the message area on the Touch Screen indicating that
transparencies must be loaded into Tray 3.
Collated must be selected on the Basic Features screen for the Transparency
Options button to appear. The Transparency Options feature cannot be used in
combination with the Covers, Inserts, Booklet Creation, or Poster features.