Xerox DocuColor 2060 - Manual (Page 217)

T R A Y 4 A C C E S S O R I E S
D O C U C O L O R 2 0 6 0 / 2 0 4 5 O P E R A T O R M A N U A L
AC
CESSO
RIES
5–5
Paper Stock Specifications
There are two positions in which paper is fed into the digital press. One of the
positions is called long edge feed (LEF). Long edge refers to the long edge of your
paper. When you see LEF, position your paper so that the long edge is fed first.
The other position is called short edge feed (SEF). Short edge refers to the short
edge of your paper. When you see SEF, position your paper so that the short edge
is fed first.
Tray 4 handles paper from a minimum of 64 g/m
2
up to 220 g/m
2
, either coated or
uncoated. It accepts all standard paper sizes supported by the DocuColor 2060/
2045, with the exception of JIS B5 LEF (Asian standard size).
Non standard sizes from 182 to 320mm (7.2 to 12.6") across the feed direction,
and 203 to 488 mm (8.0 to 19.2") in the feed direction, with the exception of some
long narrow paper sizes are also accepted by Tray 4. Paper longer than 305 mm
(12") in the feed direction must measure at least 210 mm (8.3") across the feed
direction.
Special paper stock for Tray 4:
• Letterhead (refer to Letterhead procedure in this section).
• 3 hole drilled paper is not recommended.
• Colored paper.
• Coated/Non-coated paper (coated paper less than 100 g/m
2
may not
feed as reliably as coated paper greater than 100 g/m
2
.
• Tabbed Inserts can be run but are not recommended for Tray 4. Refer to
Tabbed Inserts procedure in this section.
Tray 4 holds a maximum of 2500 sheets of 24 pound (64 - 80 g/m
2
) paper (five
reams). DO NOT fill above the MAX line.
For further instructions on loading special stock, refer to the Loading Special
Stock section in this chapter.