Xerox DocuColor 2060 - Manual (Page 246)

A C C E S S O R I E S H I G H C A P A C I T Y S T A CK E R ( H C S )
D O C U C O L O R 2 0 6 0 / 2 0 4 5 O P E R A T O R M A N U A L 5–34
Problem Solving
If, after following the recommended solutions, the problem persists, call for
assistance.
The Fault Codes described below appear on the HCS display panel.
Problem Cause Solution
Fault 052-311 Communication problem • Cancel or save the job.
• Power off the digital press. Wait 15 seconds and power on.
Fault 212-252 HCS Flipper wheel
problem. • Open Top Cover.
• Clear the paper path.
• If the fault code is still displayed, save or cancel the job, then
power off the digital press. Wait 15 seconds and power on.
Fault 212-253 HCS Flipper wheel
problem. • Open Top Cover.
• Clear the paper path.
• If the fault code is still displayed, save or cancel the job, then
power off the digital press. Wait 15 seconds and power on.
Fault 212-251 HCS Stacking Height
problem • Open Top Cover.
• Clear the paper path.
• If the fault code is still displayed, save or cancel the job, then
power off the digital press. Wait 15 seconds and power on.
Fault 212-254 HCS Registration problem • Open Top Cover.
• Clear the paper path.
• If the fault code is still displayed, save or cancel the job, then
power off the digital press. Wait 15 seconds and power on.
Ready Indicator does not
illuminate No power • Check the power cord connected to the power source.
• Check that the GFI circuit breaker is not tripped (rear cover).
• Check that the main switch is on.
Poor Stacking Mixed sizes of paper Run separate jobs and empty stacker.
High paper curl • Adjust digital press decurler.
• Flip paper in digital press paper tray(s).
• Rotate paper in the digital press paper tray(s).
• Switch to heavier paper.