Xerox DocuColor 2060 - Manual (Page 85)

O V E R V I E W
D O C U C O L O R 2 0 6 0 / 2 0 4 5 O P E R A T O R M A N U A L
OVER
VIEW
2–35
Document Glass
Figure 24. Orientation of Original
1
Lift the DADF and place the original face down in the upper-left corner using the
same orientation on the Document Glass as the paper in the chosen paper tray
(Long Edge Feed (LEF) on the glass if the paper in the chosen paper tray is LEF.
Short Edge Feed (SEF) on the glass if the paper in the chosen paper tray is SEF).
CAUTION: When copying a bound document, DO NOT apply excessive force
to close the DADF.
2
Lower the Duplex Automatic Document Feeder.
3
Press the Start button to begin the scan operation.
The maximum scanned image size is 11 x 17 inches or A3. To copy an image of
this size onto 12 x 17.7 inch or SRA3 paper, you must select 102
% enlargement.
Refer to the Paper and Paper Trays Chapter of this manual for more information
on programming the system for the various paper sizes.
KEY POINT: You may not use the Auto Color option if the Duplex Automatic
Document Feeder must remain open during copying. The digital press with
scanner will not operate until you make a different selection under the Color
Mode feature.