Function commands, Configuration – AASTRA 1560_1560ip User Guide User Manual
Page 87
Configuration
eud-1431/1.0 – OIP R8.3 – 02.2012
87
Function commands
You can use function commands to define a function to suit your personal require-
ments.
A function can consist of one or more function commands, function codes, and the
phone number. You can either carry out a function directly or store it under a function
key (select
Free configurable
function).
The following function commands are available (depending on the phone):
"A"
Seize line with highest priority
"I"
Seize line
"X"
Disconnect
"P"
Pause 1 second before the next operation
"Lxx"
Seize line xx (Line keys)
"N"
Use the phone number entered in call preparation
"."
Control key function (up-circuit system)
"Z"
Activate/deactivate DTMF mode
"R"
Use the phone number last dialled
"Y"
Disconnect and reseize the line
Examples of how to define a function:
"IR"
Seize line ("I"),
Dial phone number last dialled ("R")
"I201"
Seize line ("I") and dial phone number 201
"I
*21201X"
Seize line ("I"),
activate call forwarding unconditional ("
*21") to phone number 201,
disconnect ("X")
Notes:
• Functions that are not available via the menu can be activated using function
codes (see "User’s Guide Function Codes" on the Aastra 400
DocFinder:
).
• You can either type in a function command or code directly or store it under a
key.
• You can only activate certain function codes if the same function cannot be
obtained via the menu.
• The availability of certain function codes may be restricted depending on the
system and software version.
eud-1431_POOL_en.book Page 87 Wednesday, February 15, 2012 12:30 PM