Reset printer, Factory default, Cut fwd and cut rev – Printronix T2N User Manual
Page 102: Job capture, E 102
102
Reset Printer
The
“Reset Printer” button in the Printer Function section is a quick way to cycle printer power.
Note: This action does not reset the printer to factory default configurations. Use the
“Factory Default”
button to reset the printer’s configuration if needed.
Factory Default
The “Factory Default” button in the Printer Function section restores the factory default settings in the
printer followed by a reboot. This includes the Media/Sensor, Interface, PGL, ZGL, and EGL
configuration parameters. This procedure also affects the Advanced settings parameters with
exception of network parameters which can only be reset to their default within the Interface tab, via
the “Network Default” button.
Note: You must click
the “Read” button to load the defaults back into the Configuration Utility.
Alternatively, setting the printer to Factory Default can be performed by rebooting the printer while
holding the PAUSE and FEED keys simultaneously on the control panel.
Cut Fwd and Cut Rev
The “Cut Fwd” and “Cut Rev” buttons are used to move the cutter in both forward and reverse
directions. This tool helps clear paper jams that occur in the cutter.
Note: These two functions do not adjust the cut position.
Job Capture
The “Job Capture” feature captures the data sent to the printer in various forms. The data can then be
analyzed and/or sent to Printronix Customer Support.
Print Label
In default mode with “Print Label” selected, the data will print on the label as it is received
(see Figure 29). If the print data does not fill a label, press the Feed key to get the data to print. The
only way to disable this mode is to reboot the printer or use
the “Reset Printer” button in the Printer
Function section.
This is hex dump 54 68 69 73 20 69 73 20 68 65 78 20 64 75 6D 70
. The data is he 2E 20 54 68 65 20 64 61 74 61 20 69 73 20 68 65
x format on the 78 20 66 6F 72 6D 61 74 20 6F 6E 20 74 68 65 20
Right hand side. 72 69 67 68 74 20 68 61 6E 64 20 73 69 64 65 2E
Figure 29. Job Capture Features