Printronix T2N User Manual
Page 76
Advertising
76
Head Auto Calibrate
This option selects whether the printer does a media calibration after a Printhead Open fault.
Enable (factory default). Performs media calibration each time the Printhead Open fault
condition is cleared. The Feed key must be pressed to initiate the calibration.
Disable. No media calibration after Printhead Open fault.
Max Cal. Length
This option specifies the maximum distance to search for a gap or mark before declaring
calibration unsuccessful. Recommended length is 1.5 times the label length of the installed
media.
The factory default value is 10 inches.
Advertising