Printronix T2N - Manual (Page 116)

116
Max Cached Char
The Maximum Cached Characters option specifies the size of the largest character that can be stored
in the font cache. This will not take effect unless you save it in a configuration and the printer is
powered up with that configuration. To calculate the memory requirement, use this equation:
(HS x VS x Average Height x Average Width) / 8
Where:
HS = Horizontal resolution
VS = Vertical resolution
Average Height = Average character height (inches)
Average Width = Average character width (inches)
For example, with a printhead that prints at 203 dpi, use the following formula:
(203 x 203 x 1 x 1) / 8 = 5,151.
Therefore, select a value that is greater than or equal to 5,151.
The closest available value is 6 KB.
The allowable range is 1 KB through 20 KB, in 1 KB increments.
The factory default is 1 KB.
Standard Chars
This menu permits you to adjust the thickness or font weight of standard text fonts.
The range is 0 to 512, and the factory default is 340.
IMPORTANT: This menu does not apply to bold font types used in PGL.
Bold Chars
This menu permits you to adjust the thickness or font weight of bold text fonts.
The range is 0 to 512, and the factory default is 448.
Extra Bold Char
This menu permits you to adjust the thickness or font weight of extra bold text fonts.
The range is 0 to 512, and the factory default is 504.
OCR-A
Character weight adjustment of resident OCR-A characters.
The range is 0 to 512, and the factory default is 384.
OCR-B
Character weight adjustment of resident OCR-B characters.
The range is 0 to 512, and the factory default is 304.
Tall Characters
Increases the point height of resident Intellifont characters.

Disable (factory default). Standard resident font character point height is maintained.

Enable. Increases the point height of resident Intellifont characters approximately 10%.