Printronix T2N - Manual (Page 44)

44
Memory full (FLASH/DRAM) FLASH/DRAM is full. Delete unused files in the
FLASH/DRAM. Use the
Configuration Utility to change
the maximum value (see
Advanced Setup on page 111).
Unable to use SD card. 
SD card was inserted after
powering printer on.

SD card is damaged.

SD card does not insert
properly.

Unapproved SD card in use.
1. Use an authorized SD card.
For supported SD cards,
see page 19.
2. Reinsert the SD card and
power-up the printer.
Poor print quality. 
Ribbon and media are
loaded incorrectly.

Dust or adhesive
accumulation on the
printhead.

Print density is not set
properly.

Printhead element is
damaged.

Ribbon and media are
incompatible.

Printhead pressure is not set
properly.
1. Reload supplies.
2. Clean the printhead.
3. Clean the platen roller.
4. Adjust the print density and
print speed.
5. Run a printer self-test and
check the printhead test
pattern for missing dots.
6. Change to proper ribbon or
label media.
7. Adjust the printhead
pressure adjustment knobs.
If the left or right side of the
printout is too light, adjust the
left or right pressure
adjustment knob to the
higher index for higher
pressure. If the pressure
adjustment knob is adjusted
to 5 and the print quality is
still poor, contact the
Customer Service
Department of your reseller
or distributor for service or
instructions.
8. Ensure the deck lock lever is
latched to the pivoting deck
properly.
Cutter is not working. The connector is loose. Plug the connector cable
correctly.