Printronix T2N - Manual (Page 93)

93
EGL Tab
EGL Setup options are shown in Figure 22 along with their factory default settings. Descriptions
of each menu and their factory defaults follow.
Figure 22. EGL Setup
Print Direction
Print Direction defines the direction of feed.

0 (factory default). Feeds label head first.

1. Feeds label foot first.
Density
Print Density in the Media/Sensor tab is exclusively for PGL and ZGL. EGL uses the Density in
this tab.
The range is 0 to 15 and the factory default is 8.
Reference
This option defines the origin of the image relative to the label. The first entry defines the
horizontal (x) offset and the second entry defines the vertical (y) offset. The default is (0, 0).
Code Page
This option defines the current character set selection. The options correspond to the
EGL I command. The command syntax is IP
1
,P
2
,P
3
with three parameters. The first parameter P
1
is used to select whether 7 or 8 bit data will be used. The second parameter P
2
selects the code
page. The third parameter P
3
selects a KDU country code which is not supported in this product.