Printronix T2N - Manual (Page 55)

55
5. Push the deck lock lever to release the pivoting deck.
6. Carefully disconnect the printhead cable assembly from the printhead by pulling out the
connector.
IMPORTANT: Do not pull on the cables.
7. Replace the printhead assembly.
8. Connect the printhead cable and carefully lift the assembly into the pivoting deck.
9. Align the printhead assembly holes with the tenons, then insert.
IMPORTANT: Push the cables back underneath pivoting deck cover. Do not block the
ribbon path, otherwise the ribbon could bulge and cause wrinkles.
Printhead
Connector
Printhead
Assembly
Printhead
Assembly
Cables
Tenons
Printhead
Assembly
Holes