Printronix T2N - Manual (Page 77)

77
Interface Tab
After setup, the host interface ports are active and available. For example, one job may be sent
through USB while the next job sent through serial, followed by a third job through Ethernet.
Note: Be careful not to send the jobs at the same time or the application could misprint. The
Interface Tab (Figure 15) is shown with DHCP selected. A network connection is established for
this example.
Figure 15. Interface Tab
This section covers the following areas within the Interface Tab:

USB Setup. Sets up the printer to use the USB port for host IO (page 78).

Serial RS-232 Setup. Sets up the printer to use the serial RS-232 port for host IO
(page 78).

Ethernet Setup. Sets up the printer to use the Ethernet for host IO or for communication
with the Configuration Utility (page 79).

Ethernet Connection. How to identify and select the right printer through methods such
as using the USB, serial RS-232, or network discovery (page 80).

Web Setup. How to launch the T2N webpage and perform setup tasks via the webpage
(page 82).