B&K Precision 4034 - Manual - Manual (Page 17)

17
2. General Waveform Display
Displays the general waveform being generated in the channel.
Note: Waveform shown is approximated and scaled down. It does not show the exact representation of
the waveform at the output.
3. DEL Mode Display
Displays delay setting of the pulse. Alternatively, it can also display other parameters in other menu
items.
4. Menu Functions Display
Displays the menu options available. Use F1-F5 keys on front panel to select the options.
5. Secondary Parameter Display
Displays the values of parameters selected in the menu.
Depending on the options chosen, various parameters will display with a cursor for adjusting their values.
For example, width or duty cycle can be displayed.
6. Main Parameter Display
Displays the main parameter value. When highlighted, it can be adjusted with numeric keypad or rotary
knob. It can, for example, adjust frequency or period.
7. Mode Display
Displays the current mode of the generator. This can be the trigger mode of the power supply.
3.3 Front Panel Controls
The front-panel controls select, display, and change parameter, function, and mode settings. Use the rotary input knob
and the cursor movement keys to enter data into the pulse generator.
To change a setting:
1. Press the key that leads to a required item.
2. Move cursor using cursor keys to the appropriate position in the numeric field.
3. Use the rotary input or the numerical keyboard to change the value of the displayed item. Changes take effect
immediately.
The following subsections describe the function of each front panel key and connector.
3.4 Back Panel Controls
The pulse generator has 4 BNC Connectors on the rear panel where you can connect coaxial cables. These coaxial
connectors are labeled accordingly and serve as carrier lines for input and output signals delivered to and from the
pulse generator.