B&K Precision 4034 - Manual - Manual (Page 29)

29
time-out.
F4: POWER
- (Power-on default) Selects the power-on default setting. Select a value using the data keys or
the rotary input knob. The selection is effective after a 20s time-out period. Select zero (0) to
have the pulse generator power on with the factory default settings. Select 99 to have the pulse
generator power-on with the settings it had at the last power-off. Select any other value in the
range from 1 to 98 to have the pulse generator power-on with the settings that you have saved
with SETUPS STORE in the range 1 to 99.
Power-On Menu
NOTE: Power-on settings cannot restore the status of output at power-on, meaning if the
output is ON, power-on settings cannot recall it to be ON at start up. This setting will always
remain OFF and power on, which is same as the default setup indicated above in Table 3-2.
Although the output status can be stored into memory for recall using the store/recall functions,
it cannot be recalled for a power-on setting start up. This is due to safety concerns as sensitive
devices that are connected to the outputs of the generator may accidentally be damaged at
power-on if the power-on configurations are not set properly (i.e. Amplitude level set too high
for power-on may easily damage a sensitive device by accident).
3.7 ON Key
Use this key to control the main output signal. A build-in LED lights when the output is active.
3.8 Cursor Movement Keys
Use these keys to move the cursor (when visible) either left or right. They are used in conjunction with the rotary
input knob to set the step size of the rotary input knob.
3.9 Rotary Input Knob
Use this knob to increase and decrease numeric values or to scroll through a list. The cursor indicates the low-order
position of the displayed value which changes when you rotate the knob (for straight numeric entries only). For other
types of data, the whole value changes when you rotate the knob.