B&K Precision 4034 - Manual - Manual (Page 60)

60
BURSt
Examples: :TRIG:MODE CONT
:TRIG:MODE BURS
QUERY
Syntax: :TRIGger:MODE?
Response: CONT | TRIG | GATE | BURS
4.12.3.2 Trigger Source
This command is used to select the trigger source, for use in the Trigger, Gate and Burst trigger modes.
COMMAND TYPE: Setting or Query
SETTING
Syntax: :TRIGger:SOURce<ws><option>
Arguments:
Type: Character
Options: MANual – Front panel MAN key
BUS – GPIB trigger (GET or *TRG)
INTernal – Internal trigger
EXTernal – External trigger
Examples: :TRIG:SOUR BUS
:TRIG:SOUR INT
QUERY
Syntax: :TRIGger:SOURce?
Response: MAN | BUS | INT | EXT
4.12.3.3 Burst Count
Used to set the number of cycles to be output in the BURST mode. It is not a standard SCPI command.
COMMAND TYPE: Setting or Query
SETTING
Syntax: :TRIGger:BURSt<ws><value>
Arguments:
Type: NRf
Range: 2 to 999999
Rounding: To integer value
Examples: :TRIG:BURS 100
QUERY
Syntax: :TRIGger:BURSt?
Response: NRf
Examples: :TRIG:BURSt?
4.12.3.4 Internal Trigger Rate
Sets the rate of the internal trigger.
COMMAND TYPE: Setting or Query
SETTING
Syntax: :TRIGger:TIMer<ws><value>[units]