Section 4, Programming, 1 overview – B&K Precision 4034 - Manual User Manual
Page 35: 1 gpib, 2 rs-232-c
35
-
Pulse Definitions – Settling Time
Section 4
Programming
4.1 Overview
4.1.1 GPIB
This section provides detailed information on programming the pulse generator via the IEEE 488 bus (GPIB -
General Purpose Interface Bus). The pulse generator is programmable over the IEEE 488 bus, and its message
protocol is compatible with IEEE 488.2. The device command set is compatible with the SCPI 1992.0 standard.
The SCPI standard does not cover all the needs of the pulse generator, and so the standard has been added where
necessary.
The command syntax as defined by the IEEE 488.2 and SCPI standards is briefly explained in the following
sections. Users who have experience programming GPIB instruments may skip these paragraphs, and go directly
to where the individual command syntax is given. Users wishing to gain further insight should consult the
standards.
4.1.2 RS-232-C
Be sure that you have the Remote Mode set to RS-232 and correctly set the baud rate.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
10% AMPLITUDE
- -
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
- -
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
ACCURACY
RANGE
90% AMPLITUDE
SETTLING TIME