B&K Precision 2532B - Manual - Manual (Page 173)

173
• No signal! : The system would display this information when the
signal could not match the auto set condition. (Using in the auto
set)
• Adjust at limit! : You could adjust the pulse width by the
universal knob till the pulse width has reached min 20.0 ns or max
10.0 s.
• Location Empty! : If you have no stored waveforms or setups on
some location, the screen will display this information when you
press the “Recall” button on this location.
• USB Flash Drive Plug In! : This information will appear when
you invert the USB Flash Drive to the USB Host port.
• USB Flash Drive Pull Out! : This information will appear when
you pull out the USB Flash Drive.
• Store Data Success! : Saving setup data, waveform data or
picture data to the internal memory of the oscilloscope or USB
flash was successful.
• Ready Data Success! : Read setup data or waveform data from
the internal of the oscilloscope or USB flash successful.
• Please set Back USB to printer!
• USB Flash Drive isn’t connected! : When the “Save To” option
is set to “File” or the “Print Key” option is set to “Save Picture” in